SD Straight Grey Vehicle/Bedside Holster Sleeve

These sleeves are 3D printed with a “PLA”, corn-based plastic and is considered biodegradable under industrial processes.

Screw holes on the back side are large enough for “Sheetrock” style screws to pass through and the heads of the screws to flush finish as to not mar your launcher.  The front screw access holes are a larger diameter to easily pass a hex drill extension or standard screwdriver through so mounting is a breeze.

Canted sleeve is designed for harder to reach places where the grip of the launcher would be up against a wall, on the inside of a desk knee space or other surface where non-canted would be too tight to rapidly remove the weapon from the sleeve.

Non-canted is ideal for mounting at the top of a bedside table, at the top of a vehicle center console or under dash where the grip of the launcher would protrude beyond the mounting are which would make extraction simple and quick.

Each sleeve is individually printed and variations in color and texture are to be expected as “no two are alike”.  Sleeves are printed to a tolerance that will hold the launcher loosely in place to facilitate rapid deployment.  Horizontal mounting in a moving vehicle is not recommended.